Any one want to help me out, I'm going to attempt to make a roll bar for my 78 silver dodge macho and needed some measurement for it. Diameter of pipe and total height of it. Also looking for the height of where the bar meets and goes back to the well hump. This will get me by untill I find a good one for it.

doesnt have to be exact, just something to get me in the ball park. It's just going to temporary and defenitly will have no safety value as it will probably be made out of exhaust tubing.

Ryan....
your going to have to show us a pic of what you got....
I keep kicking myself for not buying the macho bar that was at Carlisle...

yup I'd kick you too!

And the NOS wagon wheel

I'll get you dimensions
Fri

yup, and those wagons too...rub it in, I should da bought some stuff....
you need to go to carlisle one of these days....

I never saw the roll bar , but I wasnt really looking for one either. I was buisy running around buying parts for my charger and that pretty much kept me busy all weekend. Never saw the wagon wheels as well, what the heck.

Yah Jeff your going to have to come out for it next year, it's the most fun I have all year, so many parts.

And thanks Jeff for getting me some measurements. It still has all the holes in the bed so I'll know where they go there. I'll post pictures of the truck real soon just wanted to get it cleaned up first.

3 inch OD on the tube

Top of bed floor rib to bottom center of bar 40 and 1/4

Top of bed floor rib to bottom at outer light tabs 39 and 1/2

Main bar from floor to first bend 22

Across main bar Inside at the top of the support welds 53 and3/4

Light tabs are 2 by 3 and 1/2

Outer tabs distance inside 38 Then 18 each
to middle tab

Distance mounted of bar to top of bed (front) 1 and 1/4

Top length of support bar from plate to main bar 33 and 1/4 including weld

Main plate 7 and 3/8 by 5
Support plate 5 by 3 and 1/2

Jeff your the man, thanks so much that's perfect!!!

Cool,
we want to see it when it's done!